Replacement Parts for PWS® BEV 200 Series Portable Water Filters / Purifiers

Recommended maintenance for the BEV200:

The outside of the BEV200 case can be kept clean with mild dish soap.
If not used frequently, every 90 days you should perform a 15 minute flush and produce a few gallons of water. Then flush the system again for a few minutes before returning the system to storage.
Once a year, replace the Sediment & Carbon pre-filter and the DI post-filter. (Available as a kit including 1 each pre and post filters. Part# PWS-AFRS-200)
Every 2-4 years replace the reverse osmosis membrane. (PWS-BEV-RO40) You may choose to do this on a schedule, or you can obtain a test meter from us and monitor the performance of the membrane when you change filters and/or when performing other maintenance.

	Annual Filter Replacement Set, 200 Series
	Price $130.00

Annual Filter Replacement Set (PWS-AFRS-200)

Filter set for PWS® BEV200 Series includes:
   1 ea. PWS-BEV100-012 pre-filter, and
   1 ea. PWS-BEV-RDI deionization module.
    Save $2.00 vs. buying individually.


	Price $34.00

Sediment & GAC Pre-Filter (PWS-BEV100-012)

The pre-filter in PWS® BEV-100, 200, & 500 systems is a carefully engineered design consisting of high grade, high capacity, dedusted, steam washed, granular activated carbon for adsorption of organics, chlorine and chloramines with a 10 micron sediment and colloidal debris entrapment filter.


	Price $98.00

200 Series DI Module (Flat Cap) (PWS-BEV-RDI)

The DI module for the 200 Series has flat, vs. rounded end-caps, allowing the module to fit into the portable case. (NOTE: the part number is different from the DI module for the BEV100, 300, and 500 systems.)

The deionization module in all our systems is a unique, proprietary design for use in the PWS® BEV Series appliances. No other BEV system includes this unique 4-stage module.

The first stage of this module contains a proprietary nuclear grade deionization resin carefully engineered to extract whatever is not removed by our custom reverse osmosis membrane.

The second stage contains high grade, high capacity, dedusted, steam washed, bituminous grade, granular activated carbon to polish the product water for taste.

The third and fourth stages are designed to prevent the slightest potential of reverse migration of microorganisms.


	Price $115.00

Custom RO Membrane (PWS-BEV-RO40)

The reverse osmosis membranes in the PWS® BEV Series are custom rolled, spiral wound thin film composite membrane offering consistently high rejection rates (>97%).

Do not order these until needed. Membranes have a limited shelf life and should only be ordered when you are ready to replace them.

The consistently high rejection rates allow us to match the deionization resins in the DI module (above) to those contaminants not typically removed by reverse osmosis; assuring your PWS® BEV system produces water meeting the Vincent standards for purity and bio-compatibility.

Pure Water Systems BEV-Series Drinking Water Filters / Purification Systems
have been laboratory tested and certified to conform to the
BEV standards for purity and bio-compatibility.

— Replacement Parts for BEV-200 Series Systems

Ultra Pure BEV Drinking Water

Pure Water Systems BEV-Series Drinking Water Filters / Purification Systemshave been laboratory tested and certified to conform to the BEV standards for purity and bio-compatibility.

— Replacement Parts for BEV-200 Series Systems

Ultra Pure BEV Drinking Water

Pure Water Systems BEV-Series Drinking Water Filters / Purification Systems
have been laboratory tested and certified to conform to the
BEV standards for purity and bio-compatibility.